|
The cockpit interior is made of aluminum panels. Some of
the panels are temporarily attached to the chassis with a few screws when the kit is shipped from the factory. To permanently install the panels,
holes are drilled through the panels and into the chassis frame for the rivets. The panels are bonded with silicone
and riveted in place.
I sealed all the seams between panels using metal foil tape.
Cockpit rear wall, transmission tunnel, and driver side floor: 
I put thermal insulation on the outsides and insides of the foot box
panels to reduce the engine heat and noise that gets into the cockpit.
Passenger side foot box with insulation:
Passenger side floor and foot box (I installed the insulation later):
Driver side floor and foot box:
Interior with donor wire harness installed:
There were lots of individual pieces of carpeting. With the carpet
in, the cockpit has a nice finished look.
Interior with dash, seats
and seat belts, and carpeting installed:
|
