|
|
| Snowblower as shipped |
|
| Step 3: Grease the inner chute |
|
| Step 6: Adjust Idler Pulley |
The snowblower comes partially assembled. It weighs just over 500 lbs. and was easily lifted out of the van by a boom
pole.
|
| Clearing the Lower Drive |
The snowblower is just a little wider than the tractor. It clears a path just wide enough to drive through. The gaurd
rail on the road is just visible through the trees.
|
 |
|
|
|
| Step 1: Attach A-frame |
|
| Step 4: Install chute and cable |
|
| Step 7: Fill Gear Box with Gear Oil |
Attach the AFrame, fill the gear box, grease the zerks, install the chute, attach the chute control cable and let it
snow.
Click here for a short YouTube video of the Snowblower in operation.
|
|
|
|
|
|
| Step 2: Attach Chute Control Rod |
|
| Step 5: Grease auger chain and Zerks |
|
| Step 8: Bring on the Snow... |
Ongoing maintenance is to re-lube and adjust the idler pulley. The ladder is a standard 6' to give a size reference.
|
| On the Upper Drive |
The arc from the chute depends on the wieght of the snow. The heavier the snow, the further it goes. This snow is pretty
light, so it doesn't really go that far, about 30'.
|
|
|
|
|
