|
This is the first time that enough of the project has been assembled so that a test fitting of the deck on the truck
cab be done. All of the measurements look good at this point, but until you see it in place, you just don't know if it's all
going to work.
|
| Putting The Bed Into Position |
|
| Check Rear Bracket Alignment |
|
| Support Section of Bushing |
|
| Front Bracket Alignment |
NOTE: The brackets are mounted to flanges that are bolted to the frame. See SPECIAL NOTE in the support bracket section.
After it was lifted into position, it was set onto four of the eight bushings. Each bracket was checked for alignment.
|
