V Drums / TD-6
Record Live Performance Data (MIDI) & Audio Simultaneously

TD-6:
1) Make sure MIDI COMMON > LOCAL CONTROL are set to ‘ON’ (Page 98)

2) Connect Audio Outputs to recording device (PC DAW, MultiTracker, etc.)
[Note: TD-6 Audio Outputs are Unbalanced…use ¼” TS]

3) Connect MIDI Output to MIDI Interface...to recording device

4) Open a User Song (151-250):
A) Press [SONG]…1 st User Song (151) loads by default
B) Make sure MEASURE & BEAT are set to beginning (<)
[Note: This step is to also record MIDI data internally onto TD-6...if not
desired, skip to step 5]


DAW (SONAR):

5) Connect Audio Outputs (for monitoring) to TD-6 (MIX IN)

6) Make sure Metronome (Record) is ‘OFF’

7) Set levels (MIDI & Audio), Arm; & begin recording


TD-6:
8) Press [REC], then [PLAY] ([PLAY] will flash if engaged correctly)

9) Deselect ‘Click’ (which turns light off)

10) Press [PLAY] again, to begin recording



Record Live Performance Data (MIDI)

TD-6:
1) Make sure MIDI COMMON > LOCAL CONTROL are set to ‘OFF’ (Page 98)

2) Connect MIDI Output to MIDI Interface...to recording device

3) Select Drum Kit patch (for monitoring)


DAW (SONAR):
4) Connect Audio Outputs (for monitoring) to TD-6 (MIX IN)

5) Make sure Metronome (Record) is ‘OFF’

6) Set MIDI level, Arm; & begin recording


TD-6:
7) Press [REC], then [PLAY] ([PLAY] will flash if engaged correctly)

8) Deselect ‘Click’ (which turns light off)

8) Press [PLAY] again, to begin recording