·          Strip and clean old radio right down to the bear chassis.

·          Add a new stereo system to your old AM radio.

·          Maintain the stock faceplate, mounting and look of your original radio.

·          Add AM-FM decal if specified.

·          Replace face plate glass, knobs and or bezels if needed. Knobs bezels may cost extra.

·          CD or iPod input connection box hard wired to a 5’ cable from the radio that you could mount under dash or beside console to hide it. (CD player or iPod not included)

·          Supply a 6’ Stereo input cable to connect your portable CD player or iPod to the CD input box.

·          Supply hook up instructions and wiring circuit.

 

This is the radio for the person that wants their radio to have that AM stock look to match their Car’s build sheet and be able to cruise in style with the hidden FM/CD option.

But still is just for anyone that wants to keep his or her Dash Intact!

What you would have is a great looking original AM radio that plays beautiful FM stereo by clicking one button to take it out of the AM besides being able to play your CD’s or an iPod!

 

There are a few different options that can be done to these radio’s. You can make it completely stock in appearance or go with the custom version

 

Please note that in order to perform this modification to these radios, the preset buttons must be disabled because the modern style tuner (Screw type), is not compatible with old sliding type tuner set up that originally was in the radio. They will still look original and push in and pop out but they will not move the needle.

The first old preset button is now being used to switch you from AM to FM and vise versa.

The dial in the faceplate will not flip. I will either retain your stock AM face numbers or if you don’t care about the stock look, I can put on an AM/FM combo Decal. (See Picture)

 

There is also a speaker fader bezel to adjust front to back with this radio.

It will be under the volume knob on left side.

You can still use your old tone bezel to adjust speaker balance and hide the fact you have the speaker balance adjustment altogether. Please ask if you want the speaker bezel.

The right side tuner knob will still be set up for your select bezel to be under it.

The tone is also preset to one setting.

 

This radio also has amplifier provisions, (if needed).

It also will have a 12-volt power source to connect to the remote terminal on your amplifier to turn it on with the radio.

Or you can use the same 12-volt source to send signal to a power antenna relay.

 

Note: The seller will not be responsible for any damages or injuries that may result in the use of this product because he is not personally installing this item, so buyer takes full responsibility.

And once your radio is converted it cannot be changed back.

 

 You will be amazed by the sound this old radio will put out!