CONCLUSIONS
It is risky to extrapolate any of these measurements beyond the specific transceiver model and may even be so between different units.  I suspect however, that the measurements will translate between different units of the same model pretty well.  The KWM-2A performance frankly was a pleasant surprise and the other two was rather disappointing while still providing adequate performance at a somewhat lower power level.
What is clear is that the intermodulation levels rise rapidly (no surprise) and the operator should not press the issue too hard (also no surprise).  In particular the FT-1000MP performance seemed less than the "cost level" would suggest.  The silver lining , if there is one, is that low operating power levels as suggested by these measurements are adequate for this mode,  Certainly if the results are valid (and I believe them to be) then some interesting questions arise.  Among these are:

  1. What is root cause of difference in performance?
  2. Will all tube rigs do better?
  3. Is transmitter filtering causing a significant difference?
  4. What is causing the widening of the spectrum in the FT-1000MP? PLL perturbations?


With these and other questions that will present themselves the measurements are surely a work in process and this document will be updated as new measurements are made.  I intend to measure performance prior to final amplification where output is available (e.g. transverter ports which the FT-1000MP and the KWM-2A provide) and the results will be added to the document as available

 

 

 

 

 

 

 

 

 

 

 

                                           PREVIOUS PAGE                        W5TX HOME